VL SANDOWN WAGON

The VL 'Sandown' was produced as a 'one off' by Brock and HDT for the station wagon market. The HDT Build No. of this particular car is 4240 and the vehicle was fitted from factory with the six-cylinder motor and received the HDT improved cold air intake and a big bore exhaust. Suspension consisted of Brock's 'System One' springs and gas pressure shocks. Wheels were HDT 15 x 7" Aero's complete with the flush fitting covers. Body mods consisted of a body coloured Group A Grill, Signature Series (Group Three) front air dam, rear apron, side skirts and which was all was dipped in Maranello Red.

HDT New Generation
VL Sandown Wagon
VEHICLE FACTORY SPECS

ENGINE
RB30E 3.0L EFI Straight Six Plus HDT enhaced airbox and exhuast system, Overhead cam, 2 valves / cylinder Bore x Stroke (mm): 86.0 x 85.0 Compression ratio: 9.0:1 Max Power: 114 kW Max Torque: 247 Nm

INDUCTION
Ram Tuned inlet manifold with Electronic Fuel Injection.

TRANSMISSION
5-speed manual.

CLUTCH
Single Dry Plate

STEERING
Power assisted rack and pinion

SUSPENSION
Front: Fully independant. Macpherson struts with coil springs and anti-roll bar. Rear: Live axle located by trailing arms and Panhard rod. Coil springs and anti-roll bar.

BRAKES
Ventilated discs front, drums rear.

WHEELS & TYRES
15" x 7" HDT Aero rims with flush fitting covers.

FUEL TANK
68 Litres.

NUMBER BUILT
One Only.

PRICES
Unknown

KERB MASS
1400Kg